Combustion Type Power Heater System Power Heater Fuel Pump Circuit
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK HARNESS AND CONNECTOR (HEATER ASSEMBLY - HEATER PUMP ASSEMBLY)
CHECK HARNESS AND CONNECTOR (HEATER PUMP ASSEMBLY - BODY GROUND)
INSPECT HEATER PUMP ASSEMBLY
CHECK HEATER ASSEMBLY
COMBUSTION TYPE POWER HEATER SYSTEM - Power Heater Fuel Pump Circuit |
DESCRIPTION
When the heater switch assembly (power heater switch) is turned on, the heater pump assembly receives a drive voltage from the heater assembly. The heater pump assembly provides the heater assembly with fuel necessary for combustion, allowing the heater assembly to operate.
WIRING DIAGRAM
INSPECTION PROCEDURE
1.CHECK HARNESS AND CONNECTOR (HEATER ASSEMBLY - HEATER PUMP ASSEMBLY) |
Disconnect the A97 heater assembly connector.
Disconnect the A96 heater pump assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
A97-2 (L) - A96-1 (B2)
| Always
| Below 1 Ω
|
A97-2 (L) - Body ground
| Always
| 10 kΩ or higher
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
2.CHECK HARNESS AND CONNECTOR (HEATER PUMP ASSEMBLY - BODY GROUND) |
Disconnect the heater pump assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
A96-1 (E2) - Body ground
| Always
| Below 1 Ω
|
Text in Illustration*a
| Front view of wire harness connector (to Heater Pump Assembly)
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
3.INSPECT HEATER PUMP ASSEMBLY |
Remove the heater pump assembly (LandCruiser RM000005TNE000X.html).
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
2 (B2) - 1 (E2)
| Always
| 9 to 12 Ω
|
Inspect heater pump assembly operation.
Connect a positive (+) lead from the battery to terminal 2 (B2) and a negative (-) lead to terminal 1 (E2), and check the pressure of the hose by hand.
- NOTICE:
- This inspection must be done quickly (within 10 seconds) to prevent damage to the heater pump assembly.
ResultResult
| Proceed to
|
The pressure is applied to the hose
| A
|
The pressure is not applied to the hose
| B
|
Disconnect the heater pump assembly connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
| Condition
| Specified Condition
|
A96-2 (B2) - Body ground
| Engine running, heater switch assembly (power heater switch) on
| 11 to 14 V
|
A96-2 (B2) - Body ground
| Engine running, heater switch assembly (power heater switch) off
| Below 1 V
|
Text in Illustration*a
| Front view of wire harness connector (to Heater Pump Assembly)
|