Dtc C1433 Steering Angle Sensor Internal Circuit


DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

REPLACE SPIRAL CABLE SUB-ASSEMBLY (STEERING ANGLE SENSOR)

DTC C1433 Steering Angle Sensor Internal Circuit


DESCRIPTION

Signals from the steering sensor (built into the spiral cable) are sent to the skid control ECU (built into the brake actuator assembly) through CAN communication.

DTC Code
DTC Detection Condition
Trouble Area
C1433
With the IG1 terminal voltage between 9.5 and 17.4 V, the skid control ECU receives an error signal from the steering angle sensor.
Steering angle sensor (Spiral cable sub-assembly)

WIRING DIAGRAM

Refer to DTC C1432 (LandCruiser RM000000XIM0Z7X_02.html).

INSPECTION PROCEDURE

HINT:
  1. When DTC U0073, U0123, U0124 and/or U0126 is output together with DTC C1433, inspect and repair the trouble areas indicated by DTC U0073, U0123, U0124 and/or U0126 first (LandCruiser RM000000YUO0T0X.html).
  2. When any of the speed sensors or the yaw rate and acceleration sensor has trouble, DTCs for the steering angle sensor may be stored even when the steering angle sensor is normal. When DTCs for the speed sensors or yaw rate and acceleration sensor are output together with DTCs for the steering angle sensor, inspect and repair the speed sensor and yaw rate and acceleration sensor first, and then inspect and repair the steering angle sensor.
1.REPLACE SPIRAL CABLE SUB-ASSEMBLY (STEERING ANGLE SENSOR)

  1. Replace the spiral cable sub-assembly (LandCruiser RM000000SS909QX.html).

    NOTICE:
    1. Do not remove the steering sensor from the spiral cable sub-assembly.
    2. When replacing the spiral cable sub-assembly, confirm that the replacement part is of the correct specification.

NEXT

END