Meter / Gauge System Data List / Active Test

Vehicle Interior. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
Meter Gauge Display. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25

  1. DATA LIST

  1. ACTIVE TEST

Meter / Gauge System -- Data List / Active Test



DATA LIST
HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Warm up the engine.

  2. Turn the ignition switch off.

  3. Connect the intelligent tester to the DLC3.

  4. Turn the ignition switch to ON.

  5. Turn the intelligent tester on.

  6. Enter the following menus: Engine and ECT: Powertrain / Engine and ECT / Data List / All Data.

  7. According to the display on the intelligent tester, read the Data List.

    Engine and ECT
    Tester Display
    		Measurement Item/Range
    		Normal Condition
    		Diagnostic Note
    Engine Speed
    		Engine speed/Min.: 0 rpm, Max.: 16383 rpm
    		550 to 780 rpm (When idling)
    		When the crankshaft position sensor is malfunctioning, "Engine Speed" is approximately 0 or varies greatly from the actual engine speed.
    Vehicle Speed
    		Min.: 0 km/h, Max.: 255 km/h
    		Speed indicated on speedometer
    		-


ACTIVE TEST
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.

  5. According to the display on the intelligent tester, perform the Active Test.

    ABS/VSC/TRC
    Tester Display
    		Test Part
    		Control Range
    		Diagnostic Note
    ABS Warning Light*1
    		ABS warning light
    		OFF/ON
    		Confirm that the vehicle is stopped with the ignition switch ON.
    VSC Warning Light*2
    		VSC OFF indicator light
    		OFF/ON
    		Confirm that the vehicle is stopped with the ignition switch ON.
    Brake Warning Light*1
    		Brake warning light
    		OFF/ON
    		Confirm that the vehicle is stopped with the ignition switch ON.
    Slip Indicator Light*2
    		SLIP indicator light
    		OFF/ON
    		Confirm that the vehicle is stopped with the ignition switch ON.

    1. *1:w/ Anti-lock Brake System
    2. *2: w/ VSC