Front Speed Sensor (For 2Wd) Installation

Brake. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25
Brake Control Dynamic Control Systems. Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25

  1. INSTALL FRONT SPEED SENSOR LH

  2. INSTALL FRONT WHEEL

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  4. CHECK ABS SPEED SENSOR SIGNAL

Front Speed Sensor (For 2Wd) -- Installation


HINT:
  1. The procedure listed below is for the LH side.
  2. Other than areas where instructions are provided, use the same procedure for the LH and RH sides.


1. INSTALL FRONT SPEED SENSOR LH

  1. Install the 2 harness clamps with the 2 bolts.

    Torque:
    32 N*m{326 kgf*cm, 24 ft.*lbf}
    NOTICE:
    1. When installing the clamp, do not twist the wire harness.
    2. Make sure the clamp rotation stopper touches the installation position.

  1. Install the speed sensor with the bolt.

    Torque:
    8.5 N*m{87 kgf*cm, 75 in.*lbf}
    NOTICE:
    1. Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
    2. While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.
    3. After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
    4. When installing the sensor, do not twist the wire harness.


    Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25.Brake Control Dynamic Control Systems.Anti-Lock Brake System.Front Speed Sensor (For 2Wd) Installation

  1. Install the harness clamp with the bolt.

    Torque:
    32 N*m{326 kgf*cm, 24 ft.*lbf}
    NOTICE:
    1. When installing the clamp, do not twist the wire harness.
    2. Make sure the clamp rotation stopper touches the installation position.


    Hilux. Tgn26, 36 Kun25, 26, 35, 36 Ggn25.Brake Control Dynamic Control Systems.Anti-Lock Brake System.Front Speed Sensor (For 2Wd) Installation

  1. Install the harness clamp with the bolt.

    Torque:
    32 N*m{326 kgf*cm, 24 ft.*lbf}
    NOTICE:
    1. When installing the clamp, do not twist the wire harness.
    2. Make sure the clamp rotation stopper touches the installation position.

  1. Attach the clamp.

  1. Connect the connector.

    NOTICE:
    1. Do not attach the connector to the radiator fan shroud before connecting the connector.
    2. Securely connect the connector.

  1. Attach the 2 clamps and the connector.

    NOTICE:
    When attaching the clamps, do not twist the wire harness.


2. INSTALL FRONT WHEEL
Torque:
152 N*m{1550 kgf*cm, 112 ft.*lbf}


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (HILUX_TGN26 RM000004QR300CX.html).


4. CHECK ABS SPEED SENSOR SIGNAL
(HILUX_TGN26 RM000000XHT0BEX.html)