Steering Angle Sensor (W/ Vsc) Removal

Remove the 2 screws <B>.

Disengage the 5 claws, 2 guides and 2 clips, and then remove the lower instrument panel finish panel sub-assembly.

Push the right and left sides of the lower steering column cover, and disengage the 4 claws.

Insert your fingers into the opening of the tilt lever of the lower steering column cover to disengage the claw.

HINT:

Spread the claw to disengage it.

Using a screwdriver, insert the tip into each service hole to disengage the 2 claws and remove the lower steering column cover as shown in the illustration.

Disengage the claw and the 2 pins, and remove the upper steering column cover.

w/ Horn Button Wire Harness:

1. Disconnect the connector to remove the horn button wire sub-assembly.
   

Disconnect the connectors from the spiral cable with steering angle sensor.

NOTICE:

When disconnecting the airbag connector, take care not to damage the airbag wire harness.

Disengage the 3 claws and remove the spiral cable with steering angle sensor.

Disengage the 6 claws and 2 pins, and remove the steering angle sensor from the spiral cable.