Manual Transaxle Assembly Removal
REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
INSTALL ENGINE HANGER
REMOVE FRONT ENGINE MOUNTING INSULATOR
REMOVE REAR ENGINE MOUNTING INSULATOR
REMOVE STARTER ASSEMBLY
REMOVE MANUAL TRANSAXLE ASSEMBLY
REMOVE ENGINE MOUNTING BRACKET LH
REMOVE FRONT ENGINE MOUNTING BRACKET
REMOVE REAR ENGINE MOUNTING BRACKET
REMOVE MANUAL TRANSMISSION CASE PROTECTOR
REMOVE WIRE HARNESS CLAMP BRACKET
Manual Transaxle Assembly -- Removal |
| 1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE |
- HINT:
- See the steps from "Discharge Fuel System Pressure" through "Remove Engine Assembly with Transaxle" (COROLLA_ZRE142 RM000001BC301CX.html).
Install the No. 1 and No. 2 engine hangers with new bolts as shown in the illustration.
- Torque:
- 38 N*m{387 kgf*cm, 28 ft.*lbf}
Item
| Part No.
|
No. 1 engine hanger
| 12281-28010
|
No. 2 engine hanger
| 12282-28010 or 12282-AB010
|
Bolt
| 90080-10177
|
Using an engine sling device and a chain block, suspend the engine assembly with transaxle.
| 3. REMOVE FRONT ENGINE MOUNTING INSULATOR |
Remove the through bolt and nut, and separate the front engine mounting insulator.
| 4. REMOVE REAR ENGINE MOUNTING INSULATOR |
Remove the through bolt and separate the rear engine mounting insulator.
| 5. REMOVE STARTER ASSEMBLY |
Disconnect the terminal 50 connector from the starter assembly.
Remove the nut and disconnect the wire harness from terminal 30.
Remove the 3 bolts, clutch accumulator bracket, wire harness clamp bracket and starter assembly.
| 6. REMOVE MANUAL TRANSAXLE ASSEMBLY |
Remove the 6 bolts.
Remove the 4 bolts and the manual transaxle.
| 7. REMOVE ENGINE MOUNTING BRACKET LH |
Remove the 3 bolts and the engine mounting bracket LH.
| 8. REMOVE FRONT ENGINE MOUNTING BRACKET |
Remove the 3 bolts and the front engine mounting bracket.
| 9. REMOVE REAR ENGINE MOUNTING BRACKET |
Remove the 3 bolts and the rear engine mounting bracket.
| 10. REMOVE MANUAL TRANSMISSION CASE PROTECTOR |
Remove the 2 bolts and the manual transmission case protector.
| 11. REMOVE WIRE HARNESS CLAMP BRACKET |
Remove the bolt and wire harness clamp bracket.
Remove the bolt and wire harness clamp bracket.
