Engine Immobiliser System (W/ Smart Key System) Id Code Box Power Source Circuit
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
CHECK HARNESS AND CONNECTOR (ID CODE BOX - BATTERY)
CHECK HARNESS AND CONNECTOR (ID CODE BOX - BODY GROUND)
ENGINE IMMOBILISER SYSTEM (w/ Smart Key System) - ID Code Box Power Source Circuit |
DESCRIPTION
This circuit provides power to operate the ID code box (immobiliser code ECU).
WIRING DIAGRAM
INSPECTION PROCEDURE
- NOTICE:
- If the ID code box (immobiliser code ECU) is replaced, register the ECU code and ECU communication ID (COROLLA_ZRE142 RM000000QYF05AX.html).
| 1.CHECK HARNESS AND CONNECTOR (ID CODE BOX - BATTERY) |
Disconnect the ID code box (immobiliser code ECU) connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
| Condition
| Specified Condition
|
E22-1 (+B) - Body ground
| Always
| 11 to 14 V
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR, OR REPLACE FUSE |
|
|
| 2.CHECK HARNESS AND CONNECTOR (ID CODE BOX - BODY GROUND) |
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
| Condition
| Specified Condition
|
E22-8 (GND) - Body ground
| Always
| Below 1 Ω
|
| | REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
