Front Airbag Sensor Removal

Vehicle Interior. Corolla. Zre142 Aze141
Supplemental Restraint Systems. Corolla. Zre142 Aze141

  1. PRECAUTION

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. REMOVE HEADLIGHT ASSEMBLY

  4. REMOVE FRONT AIRBAG SENSOR

Front Airbag Sensor -- Removal


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.


1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing (COROLLA_ZRE142 RM000000KT10H0X.html).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


3. REMOVE HEADLIGHT ASSEMBLY
(COROLLA_ZRE142 RM000003FYF004X.html)


4. REMOVE FRONT AIRBAG SENSOR

  1. Check that the ignition switch is off.

  1. Check that the cable is disconnected from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


    Corolla. Zre142 Aze141

  1. Disconnect the connector from the front airbag sensor.

    NOTICE:
    When disconnecting the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the bolt and front airbag sensor from the body.

    NOTICE:
    Loosen the bolt while holding the front airbag sensor because the front airbag sensor pin (stopper) is easily damaged.