Spiral Cable -- Removal |
| 1. REMOVE STEERING WHEEL ASSEMBLY |
| 2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY |
Remove the 2 screws <B>.
 |
Disengage the 5 claws, 2 guides and 2 clips, and then remove the lower instrument panel finish panel sub-assembly.
 |
| 3. REMOVE LOWER STEERING COLUMN COVER |
- NOTICE:
- Removing the lower steering column cover in the incorrect order will cause the lower steering column cover to break.
Push the right and left sides of the lower steering column cover, and disengage the 4 claws.
 |
Insert your fingers into the opening of the tilt lever of the lower steering column cover to disengage the claw.
- HINT:
- Spread the claw to disengage it.
 |
Using a screwdriver, insert the tip into each service hole to disengage the 2 claws and remove the lower steering column cover as shown in the illustration.
| 4. REMOVE UPPER STEERING COLUMN COVER |
Disengage the claw and the 2 pins, and remove the upper steering column cover.
 |
| 5. REMOVE SPIRAL CABLE (w/o VSC) |
w/ Horn Button Wire Harness:
Disconnect the connector to remove the horn button wire sub-assembly.
Disconnect the connectors from the spiral cable.
- NOTICE:
- When disconnecting the airbag connector, take care not to damage the airbag wire harness.
 |
Disengage the 3 claws and remove the spiral cable.
| 6. REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR (w/ VSC) |
w/ Horn Button Wire Harness:
Disconnect the connector to remove the horn button wire sub-assembly.
Disconnect the connectors from the spiral cable with steering angle sensor.
- NOTICE:
- When disconnecting the airbag connector, take care not to damage the airbag wire harness.
|
Disengage the 3 claws and remove the spiral cable with steering angle sensor.
| 7. REMOVE SPIRAL CABLE (w/ VSC) |
Disengage the 6 claws and 2 pins, and remove the spiral cable from the steering angle sensor.
 |