Can Communication System (For Lhd) Center Airbag Sensor Communication Stop Mode

Communication System. Camry. Acv40 Gsv40
Can Communication. Camry. Acv40 Gsv40

DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

CHECK OPEN IN CAN BUS WIRE (CENTER AIRBAG SENSOR BRANCH WIRE)

CHECK WIRE HARNESS (IG2, E1, E2)

CAN COMMUNICATION SYSTEM (for LHD) - Center Airbag Sensor Communication Stop Mode


DESCRIPTION


Detection Item
Symptom
Trouble Area
Center Airbag Sensor Communication Stop Mode
  1. "SRS Airbag" is not displayed on the "Communication Bus Check" screen of the intelligent tester
  2. Applies to "Center Airbag Sensor Communication Stop Mode" in the "DTC COMBINATION TABLE"
  1. Power source circuit of the center airbag sensor
  2. Center airbag sensor branch wire or connector
  3. Center airbag sensor assembly

WIRING DIAGRAM


Camry. Acv40 Gsv40.Can Communication.Can Communication System (For Lhd).Can Communication System (For Lhd) Center Airbag Sensor Communication Stop Mode


INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistance of the CAN main wire and CAN branch wires.
  2. After the ignition switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.
HINT:
Operating the ignition switch, any other switches or any triggers related ECU and sensor communication on the CAN, which would cause resistance reading variations.
1.CHECK OPEN IN CAN BUS WIRE (CENTER AIRBAG SENSOR BRANCH WIRE)

  1. Turn the ignition switch off.

  1. Disconnect the center airbag sensor connector.



    Camry. Acv40 Gsv40.Can Communication.Can Communication System (For Lhd).Can Communication System (For Lhd) Center Airbag Sensor Communication Stop Mode

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    		Condition
    		Specified Value
    E30-13 (CANH) - E30-22 (CANL)
    		Ignition switch off
    		54 to 69 Ω


NG
REPAIR OR REPLACE CENTER AIRBAG SENSOR BRANCH WIRE OR CONNECTOR
OK


2.CHECK WIRE HARNESS (IG2, E1, E2)


    Camry. Acv40 Gsv40.Can Communication.Can Communication System (For Lhd).Can Communication System (For Lhd) Center Airbag Sensor Communication Stop Mode

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    		Condition
    		Specified Value
    E30-25 (E1) - Body ground
    		Always
    		Below 1 Ω
    E30-26 (E2) - Body ground
    		Always
    		Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    		Condition
    		Specified Value
    E30-21 (IG2) - Body ground
    		Ignition switch on
    		10 to 14 V


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY