Electrical Key Oscillator (For Front Door) Removal

Disengage the 2 clips and remove the front door lower frame bracket garnish.

Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws, and remove the front door inside handle bezel plug.

Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and remove the assist grip cover.

Using a screwdriver with the tip wrapped with protective tape, disengage the claw and remove the courtesy light assembly.

Disconnect the connector.

Remove the 3 screws and clip (A).

Using a clip remover, disengage the 9 clips.

Pull up the front door trim board in the direction indicated by the arrow.

Disengage the reference bosses from the front door panel.

Raise the front door trim board to disengage the 4 claws and remove the front door trim board together with the front door inner glass weatherstrip.

Disengage the 2 claws and disconnect the front door inside handle sub-assembly.

Using a screwdriver, disengage the 4 clips as shown in the illustration and remove the front door inner glass weatherstrip from the front door trim board.

Disconnect the front door lock remote control cable and front door inside locking cable and remove the front door inside handle sub-assembly.

Disconnect the connector.

Remove the 4 bolts and front No. 1 speaker assembly.

NOTICE:

Do not touch the cone part of the speaker.

Disconnect the connector and each clamp, and remove the front door service hole cover.

HINT:

Remove the remaining butyl tape on the door side.

Connect the front power window regulator motor assembly connector.

Connect the power window regulator master switch assembly and move the front door glass sub-assembly so that the door glass bolts can be seen.

Remove the 2 bolts.

NOTICE:

After the bolts are removed, the door glass may fall, causing damage.

Remove the front door glass sub-assembly as shown in the illustration.

NOTICE:

Do not damage the door glass.

Disconnect the power window regulator master switch assembly and front power window regulator motor assembly connector.

Remove the hole plug.

Using a "TORX" socket wrench (T30), loosen the screw and remove the front door outside handle cover and the door lock key cylinder as a unit.

HINT:

The screw cannot be removed because it is integrated into the front door outside handle frame sub-assembly.

Using a screwdriver, disengage the 2 claws and remove the front door outside handle cover.

Disconnect the connector.

Remove the front door outside handle assembly as shown in the illustration.

Disengage the 3 claws and remove the front door front outside handle pad.

Disengage the 2 claws and remove the front door rear outside handle pad.

Disconnect the connector.

Disengage the 2 clamps.

Disengage the claws and remove the front door outside handle frame sub-assembly.

Remove the screw and door electrical key oscillator.