Front Seatback Heater - Installation(2007/12 - 2009/01)

1. Install front separate type seatback cover

2. Install separate type front seatback cover with pad

3. Install front seat headrest support

4. Install front seat headrest support

5. Install front seatback board sub-assembly

6. Install front inner seat cushion shield

7. Install front seat inner belt assembly

8. Install front seat cushion shield assembly

9. Install slide and vertical power seat switch knob

10. Install reclining power seat switch knob

11. Install front seat assembly

12. Install inner seat track bracket cover

13. Install seat track cover

14. Install front seat headrest assembly

​

1. Using hog ring pliers, install the front separate type seatback cover to the front separate type seatback pad with 10 new hog rings.

   NOTICE:

   1. Be careful not to damage the cover.
      
   2. When installing the hog rings, take care to minimize wrinkles as much as possible.
      

1. Install the front seat inner belt assembly with the nut.

   Torque:

   42 N*m{428 kgf*cm, 31 ft.*lbf}

   NOTICE:

   Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding parts of the front seat adjuster.

2. for Driver seat:
   

   1. Connect the connectors and engage the 4 clamps.

3. for Passenger seat:
   

   1. Connect the connector and engage the 3 clamps.

1. Place the seat in the cabin.

2. Connect the connectors under the seat.

3. Connect the cable to the negative (-) battery terminal.

4. Move the front seat assembly fully forward by operating the slide and vertical power seat switch knob.

   NOTICE:

   Check that the seat is locked.

5. Temporarily install the front side of the front seat assembly with the 2 bolts.

6. Move the front seat assembly fully forward by operating the slide and vertical power seat switch knob.

   NOTICE:

   Check that the seat is locked.

7. Temporarily install the rear side of the front seat assembly with the 2 bolts.

8. Move the front seat assembly to the rearmost position by operating the slide and vertical power seat switch knob.

   NOTICE:

   Check that the seat is locked.

9. Fully tighten the 2 bolts on the front side of the front seat assembly in the order of the inner side bolt and then the outer side bolt.

   Torque:

   37 N*m{377 kgf*cm, 27 ft.*lbf}

10. Move the front seat assembly fully forward by operating the slide and vertical power seat switch knob.

    NOTICE:

    Check that the seat is locked.

11. Fully tighten the 2 bolts on the rear side of the front seat assembly in the order of the inner side bolt and then the outer side bolt.

    Torque:

    37 N*m{377 kgf*cm, 27 ft.*lbf}

1. Slide the inner seat track bracket cover along the seat rail toward the front of the vehicle. Engage claw A to the seat rail.

2. Push the inner seat track bracket cover to engage claw B.

1. Slide the seat track cover along the seat rail toward the front of the vehicle. Engage claw A to the seat rail.

2. Push the seat track cover to engage claw B.