Lumbar Support Adjuster Assembly - Removal(2006/01 - 2007/12)

1. Remove front seat headrest assembly

2. Remove seat track cover

3. Remove inner seat track bracket cover

4. Remove front seat assembly

5. Remove reclining power seat switch knob

6. Remove slide and vertical power seat switch knob

7. Remove front seat cushion shield assembly

8. Remove front seat inner belt assembly

9. Remove front seat cushion shield inner

10. Remove front seatback board sub-assembly

11. Remove front seat headrest support

12. Remove front seat headrest support

13. Remove front separate type seatback cover with pad

14. Remove lumbar support adjuster assembly

​

1. Operate the power seat switch knob and move the seat to the position farthest forward.

2. Using a screwdriver, detach the 4 claws and remove the seat track cover.

   HINT:

   Tape the screwdriver tip before use.

1. Using a screwdriver, detach the 4 claws and remove the inner seat track bracket cover.

1. Operate the power seat switch knob and move the seat to the rearmost position.

2. Remove the 2 bolts on the front seat track bracket.

3. Operate the power seat switch knob and move the seat to the position farthest forward.

4. Remove the 2 bolts on the rear seat track bracket.

5. Disconnect the cable from the negative (-) battery terminal.

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent the airbag and seat belt pretensioner from deploying (Click here).

6. Disconnect the connectors under the seat. Then remove the front seat assembly.

1. Using a screwdriver, detach the reclining power seat switch knob.

   HINT:

   Tape the screwdriver tip before use.

1. Using a screwdriver, detach the slide and vertical power seat switch knob.

   HINT:

   Tape the screwdriver tip before use.

1. Disconnect the 2 hooks.

2. Remove the 5 screws.

3. Disengage the claw and separate the front seat cushion shield assembly.

4. Disconnect the connector from the front power seat lumbar switch.

1. for Driver seat:
   

   1. Disconnect the connectors and disengage the 4 clamps.

2. for Passenger seat:
   

   1. Disconnect the connector and disengage the 3 clamps.

3. Remove the nut and front seat inner belt assembly.

1. Remove the screw.

2. Using a clip remover, detach the clip.

3. Using a screwdriver, detach the claw and remove the front inner seat cushion shield.

   HINT:

   Tape the screwdriver tip before use.

1. Remove the 2 screws.

2. Disconnect the 14 clamps and front separate type seatback cover.

3. Pull the seatback board in the direction indicated by the arrow in the illustration to detach the 2 claws. Then, remove the seatback board.

1. Detach the 2 claws and remove the headrest support.

1. Remove the 2 hog rings and 3 hooks.

2. Remove the nut and 2 seatback cover brackets.

3. Remove the front separate type seatback cover with pad.

1. Disconnect the connector.

2. Remove the 2 screws and lumbar support adjuster.