Meter - Gauge System - Meter Illumination Does Not Dim At Night(2007/12 - 2009/01)

Brand:

Toyota

Model Name:

Camry ACV40 GSV40

Manual:

Repair Manual

Section:

Meter

Title:

Meter - Gauge System

  1. Description

  2. Wiring diagram

  3. Inspection procedure

  4. Check can communication system

  5. Check dtc

  6. Perform active test using intelligent tester

  7. Replace combination meter assembly

METER / GAUGE SYSTEM > Meter Illumination does not Dim at Night


​

DESCRIPTION

The meter CPU receives auto dimmer signals from the main body ECU via the CAN communication lines (CAN No. 1 Bus). When the meter CPU receives an auto dimmer signal, it dims the meter illumination. The main body ECU determines whether it is daytime, twilight, or nighttime based on the waveform transmitted from the automatic light control sensor. If the main body ECU determines that it is daytime, the ECU does not send auto dimmer signals. Therefore, the meter illumination (warning and indicator lights) will not dim even if the driver accidentally turns the light control switch to the TAIL or HEAD position in daytime.

WIRING DIAGRAM


Check if CAN communication DTC is output (Click herefor LHD, Click here for RHD).Result:ResultProceed toCAN communication DTC is not output.ACAN communication DTC is output.B (Click herefor LHD, Click here for RHD) Camry


INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if CAN communication DTC is output (Click herefor LHD, Click here for RHD).

    Result:

    Result
    Proceed to
    CAN communication DTC is not output.
    A
    CAN communication DTC is output.
    B (Click herefor LHD, Click here for RHD)


Bnext
GO TO CAN COMMUNICATION SYSTEM
A
next down

2.CHECK DTC
  1. Check if DTC B1244 is output (Click here).

    Result:

    Result
    Proceed to
    B1244 is not output
    A
    B1244 is output
    B (Click here)


Bnext
GO TO LIGHTING SYSTEM
A
next down

3.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Turn the tester ON.

  1. Light control switch TAIL/HEAD.

  1. Enter the following menus: Diagnosis / Body / Main Body / Active Test.

  1. Check the meter illumination.


Main Body:
Tester Display
Measurement Item/Range
Diagnostic Note
Dimmer Sig
Auto dimmer signal ON/OFF
-
OK:
The meter illumination is dimmed when the Dimmer Sig is ON.
HINT:
Refer to the sensitivity setting in the customization table of the automatic light control system. (Click here)


NGnext
Go to step 4
OK
next down
CHECK LIGHTING SETTING

4.REPLACE COMBINATION METER ASSEMBLY
  1. Replace the combination meter assembly with a new or a normal one.

OK:
The operation of the combination meter assembly returns to normal.


NGnext
REPLACE MAIN BODY ECU
OK
next down
END