Toyota
Camry ACV40 GSV40
Repair Manual
Lighting
Lighting System
Check harness and connector (light - battery and instrument panel j/b assembly)
Check harness and connector (light - battery and instrument panel j/b assembly)
LIGHTING SYSTEM > Interior Light Circuit
DESCRIPTION
The main body ECU controls the illuminated entry system (interior light and ignition key cylinder light).WIRING DIAGRAM

INSPECTION PROCEDURE
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position and turn the intelligent tester main switch on.
Select the item(s) below in the ACTIVE TEST, and check the operation.
Main Body (Main Body ECU): Item Test Details Diagnostic Note INTERIOR LAMP Interior light and ignition key cylinder light ON / OFF (Interior light switch is in DOOR position and all doors are closed). -
- OK:
- Each light illuminates.
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE | |||
| NG | |
![]() |
Check the vehicle condition.
- Result:
Condition Proceed to without Sliding Roof A with Sliding Roof B
| Go to step 4 | |||
| A | |
![]() |

Disconnect the E25 transponder key amplifier connector.
Disconnect the Q9 rear room light assembly connector.
Disconnect the IR and II instrument panel J/B assembly connectors.
Measure the voltage and resistance according to the value(s) in the table below.
- Standard voltage:
Tester Connection Condition Specified Condition E25-2 - Body ground Always 10 to 14 V Q9-1 - Body ground Always 10 to 14 V
- Standard resistance:
Tester Connection Condition Specified Condition II-10 - E25-6 Always Below 1 Ω IR-5 - Q9-2 Always Below 1 Ω II-10 - Body ground Always 10 kΩ or higher IR-5 - Body ground Always 10 kΩ or higher
| REPAIR OR REPLACE HARNESS OR CONNECTOR | |||
| OK | |
![]() | |
| REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY | |

Disconnect the E25 transponder key amplifier connector.
Disconnect the Q6 overhead J/B connector.
Disconnect the IR and II instrument panel J/B assembly connectors.
Measure the voltage and resistance according to the value(s) in the table below.
- Standard voltage:
Tester Connection Condition Specified Condition E25-2 - Body ground Always 10 to 14 V Q6-7 - Body ground Always 10 to 14 V
- Standard resistance:
Tester Connection Condition Specified Condition II-10 - E25-6 Always Below 1 Ω IR-5 - Q6-6 Always Below 1 Ω II-10 - Body ground Always 10 kΩ or higher IR-5 - Body ground Always 10 kΩ or higher
| REPAIR OR REPLACE HARNESS OR CONNECTOR | |||
| OK | |
![]() | |
| REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY | |



