Outer Rear View Mirror - Removal(2010/08 - )

1. Remove front door lower frame bracket garnish

2. Remove front door inside handle bezel plug

3. Remove assist grip cover

4. Remove courtesy light assembly

5. Remove front door trim board sub-assembly

6. Remove front door inner glass weatherstrip

7. Remove outer rear view mirror assembly with cover

8. Remove outer rear view mirror glass (w/o mirror heater)

9. Remove outer rear view mirror glass (w/ mirror heater)

10. Remove outer mirror cover

11. Remove side turn signal light assembly

​

1. Disengage the 2 clips and remove the front door lower frame bracket garnish.

1. Using a screwdriver with the tip wrapped with protective tape, disengage the 3 claws, and remove the front door inside handle bezel plug.

1. Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and remove the assist grip cover.

1. Using a screwdriver with the tip wrapped with protective tape, disengage the claw and remove the courtesy light assembly.

2. Disconnect the connector.

1. Remove the 3 screws and clip (A).

2. Using a clip remover, disengage the 9 clips.

3. Pull up the front door trim board in the direction indicated by the arrow.

4. Disengage the reference bosses from the front door panel.

5. Raise the front door trim board to disengage the 4 claws and remove the front door trim board together with the front door inner glass weatherstrip.

6. Disengage the 2 claws and disconnect the front door inside handle sub-assembly.

1. Using a screwdriver, disengage the 4 clips as shown in the illustration and remove the front door inner glass weatherstrip from the front door trim board.

1. Disconnect the connector.

2. Remove the 3 nuts.

3. Disengage the claw and remove the outer rear view mirror assembly with cover.

1. Apply protective tape to the bottom of the visor of the door mirror.

2. Push the upper part of the mirror surface to tilt it.

3. Insert a screwdriver between the mirror holder (black) and the plate pivot (white) to disengage the 2 claws as shown in the illustration.

   HINT:

   Insert a screwdriver and turn it to disengage the claws between the mirror holder and plate pivot.

   NOTICE:

   Attempts to pull out the mirror holder without disengaging the claws may cause the actuator or the mirror to break. Be sure to disengage the claws completely.

4. Push the lower part of the plate pivot (white).

5. Disengage the 2 claws on the upper part of the mirror holder (black) to remove the mirror glass.

1. Apply protective tape to the bottom of the visor of the door mirror.

2. Push the upper part of the mirror surface to tilt it.

3. Insert a screwdriver between the mirror holder (black) and the plate pivot (white) to disengage the 2 claws as shown in the illustration.

   HINT:

   Insert a screwdriver and turn it to disengage the claws between the mirror holder and plate pivot.

   NOTICE:

   Attempts to pull out the mirror holder without disengaging the claws may cause the actuator or the mirror to break. Be sure to disengage the claws completely.

4. Push the lower part of the plate pivot (white).

5. Disengage the 2 claws on the upper part of the mirror holder (black) to separate the mirror glass.

6. Disconnect the connector and remove the outer rear view mirror glass.

1. Disengage the 7 claws and remove the outer mirror cover.

1. Remove the 3 screws.

2. Disconnect the connector and remove the side turn signal light assembly.