Sliding Roof Housing - Reassembly

1. Install sliding roof drive cable sub-assembly

2. Adjust fully closed position

3. Install sunshade trim sub-assembly

4. Install sliding roof drive gear sub-assembly

​

1. Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to install it.
   

   
   
   
   

   NOTICE:

   Make sure that the spring indicated by the arrow in the illustration is securely installed.

   HINT:

   Hold the window deflector down, as shown in the illustration, until the sliding roof drive cable sub-assembly runs on the window deflector.

2. Engage the 2 claws and install the sliding roof drip channel.

3. Install the 2 sliding roof side stoppers with the 2 screws.

   Torque:

   2.0 N*m{20 kgf*cm, 18 in.*lbf}

1. Using a screwdriver, slide the sliding roof drive cable sub-assembly in either direction as indicated by the arrows in the illustration and align the matchmarks.

   HINT:

   Tape the screwdriver tip before use.

1. Insert the sunshade trim into the sliding roof housing sub-assembly.

2. Install the sliding roof piece sub-assemblies LH and RH with the 2 screws.

   Torque:

   2.0 N*m{20 kgf*cm, 18 in.*lbf}

1. Install the sliding roof drive gear sub-assembly with the 2 bolts.

   Torque:

   5.4 N*m{55 kgf*cm, 48 in.*lbf}

2. Engage the claw and install the sliding roof drive gear bracket.