Power Window Control System (For Models With Jam Protection Function On 4 Windows) - Jam Protection Function Does Not Operate(2009/01 - 2010/08)

Brand:

Toyota

Model Name:

Camry ACV40 GSV40

Manual:

Repair Manual

Section:

Windshield - Windowglass

Title:

Power Window Control System (For Models With Jam Protection Function On 4 Windows)

  1. Description

  2. Inspection procedure

  3. Perform initialization (applicable location)

  4. Check power window control system (auto up/down function)

  5. Check jam protection function operating range

POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on 4 Windows) > Jam Protection Function does not Operate


​

DESCRIPTION

This symptom may occur for any of the windows.
The jam protection function operates within a specified range during the manual up or auto up operation.

INSPECTION PROCEDURE

NOTICE:
  1. The power window control system uses a multiplex communication system (LIN communication system). Inspect the communication function by following How to Proceed with Troubleshooting (Click here). Troubleshoot the power window control system after confirming that the communication system is functioning properly.
  2. When the power window regulator motor assembly is reinstalled or replaced, the power window control system must be initialized.
  3. After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be reinitialized by repeating the following operations at least 5 times:
    1. Close the power window by fully pulling up the power window regulator master switch assembly or power window regulator switch assembly and holding it at the auto up position.
    2. Open the power window by fully pushing down the power window regulator master switch assembly or power window regulator switch assembly.
1.PERFORM INITIALIZATION (APPLICABLE LOCATION)

  1. Initialize the power window regulator motor assembly (applicable location) (Click here).


NEXT
next down

2.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION)

  1. Check if the power window auto up/down function operates normally (Click here).

    OK:
    Auto up/down function is normal.


NGnext
GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table) (Click here)
OK
next down

3.CHECK JAM PROTECTION FUNCTION OPERATING RANGE

  1. Check if the jam protection function operates normally for the applicable power window.

    HINT:
    The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.
    OK:
    Jam protection function operates normally.
    Result:
    Result
    		Proceed to
    OK
    		A
    NG (Driver side power window)
    		B
    NG (Front passenger side power window)
    		C
    NG (Rear LH side power window)
    		D
    NG (Rear RH side power window)
    		E


Bnext
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Side) (Click here)

Cnext
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Front Passenger Side) (Click here)

Dnext
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Side) (Click here)

Enext
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear RH Side) (Click here)
A
next down
END (PROBLEM DUE TO INITIALIZATION FAILURE)