Sfi System - P0116(2009/01 - 2010/08)

Brand:

Toyota

Model Name:

Camry ACV40 GSV40

Manual:

Repair Manual

Section:

2Az-Fe Engine Control System

Title:

Sfi System

  1. Description

  2. Inspection procedure

  3. Check any other dtcs output (in addition to dtc p0116)

  4. Inspect thermostat

DTC P0116 Engine Coolant Temperature Circuit Range / Performance Problem


​

DESCRIPTION

Refer to DTC P0115 (Click here).

DTC No.
DTC Detection Condition
Trouble Area
P0116
Case 1:
Engine Coolant Temperature (ECT) between -40°C and 60°C (-40°F and 140°F) when engine started, and conditions (a) and (b) are met (2 trip detection logic):
  1. (a) Vehicle driven at varying speeds (accelerated and decelerated)
  2. (b) ECT remains within 3°C (5.4°F) of initial ECT
Case 2:
ECT more than 60°C (140°F) when engine started, and conditions (a) and (b) are met (6 trip detection logic):
  1. (a) Vehicle driven at varying speeds (accelerated and decelerated)
  2. (b) ECT measurements remain within 1°C (1.8°F) of initial ECT on 6 successive occasions
  1. Thermostat
  1. ECT sensor

INSPECTION PROCEDURE

HINT:
  1. If any of DTCs P0115, P0117 or P0118 are set simultaneously with DTC P0116, the ECT sensor may have an open or a short circuit. Troubleshoot those DTCs first.
  1. Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0116)

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position and turn the tester on.

  1. Select the following menu items: Powertrain / Engine and ECT / DTC.

  1. Read the DTCs.

Result:
Display (DTC Output)
Proceed to
P0116
A
P0116 and other DTCs
B


Bnext
GO TO DTC CHART
A
next down

2.INSPECT THERMOSTAT

  1. Remove the thermostat (Click here).

  1. Measure the valve opening temperature of the thermostat.

    Standard temperature:
    80°C to 84°C (176°F to 183°F)
    HINT:
    In addition to the above check, confirm that the valve is completely closed when the temperature is below the standard.

  1. Reinstall the thermostat (Click here).



NGnext
REPLACE THERMOSTAT
OK
next down
REPLACE ENGINE COOLANT TEMPERATURE SENSOR