Engine Rear Oil Seal - Installation

1. Install engine rear oil seal

2. Install drive plate & ring gear sub-assembly

3. Install automatic transmission assembly (for 4wd)

4. Install automatic transmission assembly (for 2wd)

​

1. Apply MP grease to a new oil seal lip.

2. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

   SST

   09223-56010
   

1. Using SST, hold the crankshaft.

   SST

   09213-70011
   09330-00021
   

2. Apply adhesive to 2 or 3 threads of the mounting bolt end.

   Adhesive:

   Part No. 08833-00070, THREE BOND 1324 or equivalent
   

3. Install the front spacer, drive plate and rear spacer on the crankshaft.

4. Install and uniformly tighten the 8 mounting bolts in several steps, in the order shown in the illustration.

   Torque:

   30 N*m{301 kgf*cm, 22 ft.*lbf}

   If any one of the mounting bolts does not meet the torque specification, replace the mounting bolt.
   

5. Mark the mounting bolt with paint (Procedure "A").

6. Retighten the mounting bolts by 90° in the order shown.

7. Check that the painted mark is now at a 90° angle to the mark placed in procedure "A".

HINT:

(Click here)

HINT:

(Click here)