Engine Rear Oil Seal - Installation

1. Install engine rear oil seal

2. Install drive plate & ring gear sub-assembly

3. Install automatic transmission assembly (for 2wd)

4. Install automatic transmission assembly (for 4wd)

5. Check for engine oil leakage

​

1. Apply MP grease to a new oil seal lip.

2. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

   SST

   09223-78010
   

1. Using SST, hold the crankshaft.

   SST

   09213-54015 (91651-60855)
   09330-00021
   

2. Apply adhesive to 2 or 3 threads of the mounting bolt end.

   Adhesive:

   Part No. 08833-00070, THREE BOND 1324 or equivalent
   

3. Install the front spacer, drive plate and rear spacer on the crankshaft.

4. Using several steps, install and tighten the 8 mounting bolts uniformly in the sequence as shown in the illustration.

   Torque:

   83 N*m{846 kgf*cm, 61 ft.*lbf}

HINT:

(Click here)

HINT:

(Click here)