Engine Front Oil Seal - Installation

1. Install timing gear case or timing chain case oil seal

2. Install crankshaft pulley

3. Install fan with fluid coupling

4. Install fan and generator v belt

5. Fully tighten fan with fluid coupling

6. Install radiator support seal upper

7. Connect cable to negative battery terminal

8. Check for engine oil leakage

9. Install no. 1 engine under cover sub-assembly

10. Install v-bank cover

​

1. Apply MP grease to a new oil seal lip.

2. Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.

   SST

   09226-10010
   

HINT:

(Click here)

SST

09213-54015 (91651-60855)
09330-00021

1. Put the fan pulley to the water pump.

2. Put the fan with fluid coupling and fan shroud together.

3. Temporarily install the 4 fluid coupling nuts.

4. Tighten the 2 fan shroud bolts and radiator reserve tank bolt.

   Torque:

   5.0 N*m{51 kgf*cm, 44 in.*lbf}

5. Connect the reserve tank hose.

6. Fasten the 2 oil cooler hoses with the hose clamp.

1. While turning the belt tensioner counterclockwise, align with its holes, and then insert a bar of 6 mm (0.24 in.) into the holes to fix the belt tensioner.

2. Install the V-ribbed belt.

3. While turning the belt tensioner counterclockwise, remove the bar.

4. If it is hard to install the V-ribbed belt, perform the following procedure.
   

   1. Put the V-ribbed belt on all parts except the P/S pump, as shown in the illustration.

   2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the P/S pump.

1. Tighten the 4 fluid coupling bolts.

   Torque:

   21 N*m{214 kgf*cm, 15 ft.*lbf}

1. Connect the cable to the negative battery terminal.

   Torque:

   3.9 N*m{40 kgf*cm, 35 in.*lbf}

1. Install the engine under cover with the 4 bolts.

   Torque:

   29 N*m{296 kgf*cm, 21 ft.*lbf}

1. Install the V-bank cover with the 2 nuts.

   Torque:

   7.5 N*m{76 kgf*cm, 66 in.*lbf}