Throttle Body - Removal

1. Disconnect cable from negative battery terminal

2. Drain engine coolant

3. Remove v-bank cover

4. Remove air cleaner assembly

5. Remove throttle with motor body assembly

​

CAUTION:

To avoid the danger of being burned, do not remove the radiator cap while the engine and radiator are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator.

1. Remove the service hole cover from the engine under cover.

2. Install a vinyl hose onto the drain on the radiator side.

3. Fix the vinyl hose with tape.

4. Loosen the 3 drain plugs on the engine and radiator, and drain the coolant.

5. Remove the radiator cap.

6. Drain the coolant from the reservoir tank.

7. Tighten the 3 drain plugs.

   Torque:

   13 N*m{130 kgf*cm, 9 ft.*lbf} for the engine

8. Remove the vinyl hose from the radiator.

1. Remove the 2 nuts, then remove the V-bank cover.

1. Disconnect the ventilation hose No. 2.

2. Disconnect the vacuum hose.

3. Disconnect the mass air flow meter connector.

4. Remove the 2 wire harness clamps.

5. Loosen the 2 hose clamps.

6. Remove the 2 bolts, then remove the air cleaner.

1. Disconnect the water by-pass hose No. 5.

2. Disconnect the water by-pass hose No. 4.

3. Disconnect the throttle motor connector.

4. Remove the 4 bolts, then remove the throttle w/ motor body and gasket.